Platform, slatted, storage, and upholstered frames, with headboard and footboard attachment.
Slide rails are squared and adjusted so drawers open and close smoothly.
Queen and king frames are checked for proper centre-beam support before we finish.
Dresser drawers typically run on side-mount or under-mount metal slides, and both need to be perfectly parallel or a drawer will bind partway open. Bed frames spread the mattress’s weight across wooden or metal slats, so we check slat spacing and centre support beams before calling a frame finished, especially on wider queen and king platforms.
We match the frame components to your mattress size and room layout.
Side rails, centre supports, and headboard brackets are assembled and squared.
The case is built first, then drawer slides are installed and aligned.
We test slat support and drawer glide before considering the job complete.
We open and close each drawer fully before finishing, not just the top one, to catch any binding early.
Bolted joints are checked for tightness and flex under light pressure before we call a frame complete.
Slats and centre supports are confirmed in place so the frame is ready for the mattress right away.
A slatted frame needs the correct slat spacing for the mattress type, memory foam generally wants tighter spacing than an innerspring mattress, so it is worth checking your mattress manufacturer’s recommendation before ordering a frame. Centre support beams matter more on queen and king sizes than on a twin or double, since the wider span carries more flex under weight.
Furniture Assembly Ottawa provides professional bed frame and dresser assembly throughout Ottawa, ON. Platform beds, slatted frames, and dressers with soft-close drawer slides all rely on precise alignment during assembly, since a rail that is off by even a few millimetres can leave a drawer sticking or a slat bowing under weight.
Yes, bedroom sets are commonly booked together as a multi-item visit.
We adjust slide alignment during assembly so drawers glide and close evenly before we finish.
Yes, including wall-anchoring the mirror bracket where the manufacturer recommends it.
In most cases yes, as long as the mounting brackets or bolt pattern are compatible. We can check this with you before the visit if you are unsure.