Track alignment and hinge adjustment so doors glide or close flush, not just close.
Shelving towers, drawer inserts, and hanging rods built to the manufacturer's layout.
Tall wardrobes are secured to a wall stud to prevent tipping.
A sliding wardrobe door that binds is almost always a levelling issue in the top track rather than the door itself, so we check the case is square before installing any track hardware. Hinged doors use cam-adjustable hinges that let us fine-tune the gap after installation, and every freestanding wardrobe over the manufacturer’s height threshold gets anchored to a wall stud.
We check the manufacturer's layout and whether doors are sliding or hinged.
The wardrobe case is assembled and checked for square before doors go on.
Tracks are levelled or hinges adjusted so doors move and close correctly.
The unit is anchored to the wall where required and interior shelving is installed.
Hinges and sliding tracks are fine-tuned after installation so doors sit flush and glide smoothly, not just technically attached.
Shelving, drawer inserts, and hanging rods are installed to the manufacturer's layout before we finish.
We point out where and why a unit is being anchored, so you know what was done and where the stud was used.
A freestanding wardrobe arrives as one enclosed case with its own back and side panels, while a modular closet system is typically open shelving and rails built directly into an existing closet space using the room’s own walls. Modular systems usually take longer to plan since layout depends on the closet’s exact dimensions, while a freestanding wardrobe just needs floor space and, where required, a wall stud for anchoring.
Furniture Assembly Ottawa provides professional wardrobe and closet system assembly throughout Ottawa, ON, for freestanding wardrobes and modular closet organizers. Sliding wardrobe doors run on a top track and a bottom guide that both need to be level, while hinged doors depend on cam-adjustable hinges to sit flush against the case.
Yes, tall freestanding wardrobes are anchored to a wall stud using the included or equivalent hardware.
Yes, if it is part of a new assembly we level the track during installation so this does not happen.
Yes, including shelving towers, drawer inserts, and hanging rod sections.
Yes, as long as the components are designed to fit the space. We can review measurements with you ahead of the visit.